//--------------------------------------------------------------
/*
 * Setup up PIN-Configuration for different MCU
 * 
 * Support for:
 *    - Arduino MEGA  
*/

//--------------------------------------------------------------
//Setting PIN CONFIG:
//--------------------------------------------------------------
//Power:
#define Z21ResetPin 47  //RESET-Button-Pin bei Neustart betätigen um Standard IP zu setzten!
#define Z21ButtonPin Z21ResetPin  //Pin where the POWER-Button is conected
//DCC and Booster
#define DCCLed 3    //LED to show DCC active
#define DCCPin 6    //Pin for DCC sginal out
#define additionalOutPin 11 //Pin for true DCC Output without Shutdown adn RailCom
#define RailcomLED 13
#define RailcomPort 15
#define ShortLed 45     //LED to show Short
#define ShortExtPin 5  //Pin to detect Short Circuit of Booster (detect LOW)
#define GoExtPin  A4   //Pin for GO/STOP Signal of Booster
#define ProgRelaisPin  A5   //Pin for using Kehrschleifen-Modul
#define ACKSensePin 2 //Pin for ACK Comperator input
//Booster INT config:
#define GoIntPin 39   //Pin for inverted DCC Signal
#define ShortIntPin 41  //Pin for second Booster like TLE5206 (detect HIGH)
#define VAmpIntPin A9   //Input for Current sensor (CV read)
//#define VAmSensePin A8 //ACS712 5A Sensor (for testing only)
#define VoltIntPin A10  //Rail Voltage: Rail:100k - Sense - 4,7k - GND
#define TempPin A11     //Temp.Sense_resistor (15k) with 46k Pull-Up or DALLAS
//XpressNet
#define XNetTxRxPin  9    //XpressNet Control-Port for Send/Receive at MAX485
//LocoNet
#define LNTxPin 7    //Sending Pin for LocoNet

//--------------------------------------------------------------
//Dallas Temperatur Sensor (MEGA only):
#if defined(DALLASTEMPSENSE) && defined(MEGA_MCU)
#define ONE_WIRE_BUS TempPin
#else
#undef DALLASTEMPSENSE
#endif

#if defined(S88N)
  //Eingänge:
  #define S88DataPin A0      //S88 Data IN
  //Ausgänge:
  #define S88ClkPin A1      //S88 Clock
  #define S88PSPin A2       //S88 PS/LOAD
  #define S88ResetPin A3    //S88 Reset
#endif

//--------------------------------------------------------------
//LAN-Interface:
#define LANSSPIN 10   //Chip Select Pin of most Ethernet Shields
#define SDSSPIN 4     //Chip Select Pin SD-Card Reader on Ethernet Shield